Dulux Stellar Grey Green Zinc Phosphate Primer

High quality water-based primer
Paint Calculator
This product is currently out of stock, please visit a store or other online retailers.
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key information
  • Finish N/A
  • Coverage Up to 13m²/L
  • Drying Time Single coat at standard thickness: 30 to 40 microns
    Touch Dry: 0.5-1 hour under normal conditions
    Recoat:2-3 hours under normal conditions
  • Coats 1
Product Features
  • Good adhesion properties
  • Rust prevention properties
  • Conforms to Singapore Green label criteria
  • Water based

Product Description

Dulux Stellar Grey Green Zinc Phosphate Primer is a solvent based, anti corrosion protective primer.

Suitable for use on interior and exterior ferrous and non-ferrous metalwork including steelwork, new, weathered and pre-treated zinc and galvanised iron. It may also be applied over pre-treated aluminium. Pre-treatment with an appropriate pre-treatment primer is required to ensure good adhesion

Application Description

Brush or Roller-For painting of large surfaces like door, roller should be used to achieve optimum flow and finishing.
Thinning is usually not necessary after thorough stirring. If required, dilute up to 10% with water. Dilution above 20% will affect the performance of the paint.
Conventional Spray--Dilute with 10%-20% of water.
Airless Spray-Ready for use.

Health & Safety

Treatments such as sanding, burning off etc of paint films may generate hazardous dust and/or fumes. Wet sanding/ flatting should be used wherever possible. Work in well ventilated areas. Use suitable personal protection equipment. Wear eye/hand protection. Do not breathe vapour/ spray. Do not eat, drink or smoke when using this product. Use only in well-ventilated areas. Remove as much paints as possible from brushes and rollers before cleaning. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or shower and soap or a proprietary skin cleanser. Do not use solvents or thinners. Do not empty into water course. Safety data sheet available for professional user on request. In case of fire use foam, dry powder, AFFF or CO2 fire extinguisher- Never use water jet. If medical advice is needed, have product container or label at hand.

Tips & Advice

  • 1. Preparing the Surfaces
    Surfaces must be clean, dry, free from all defective or poorly adhering material, dirt, grease, wax etc. All surfaces should be rubbed down using a suitable abrasive paper and then dusted off. Any scrapped area should be spot primed. Light sanding on surface would ensure better subsequent intercoat adhesion.
    Ferrous surfaces should be sanded or wire-brushed to remove millscale and rust. Remove the rust thoroughly and the area should be spot-primed.
    For optimum performance, new galvanized and aluminium surfaces should be cleaned and degreased, then pre-treated with an appropriate pre-treatment primer to ensure good adhesion

    NOTE: Ensure good ventilation during application and drying.
  • 2. Cleaning
    Clean all equipment with clean water immediately after used.
  • 3. Storing
    Keep out of reach of children. Keep away from combustible material. Keep away from food, drinks and animal feed. Container must be in a secure, upright position and be tightly closed
Fetching the data, please wait...